Motorola ST7000 - Figure 3: Battery Eliminator Insertion

Figure 3: Battery Eliminator Insertion
+ve
GND
+ve
GND
1
2
No. Description
1 Battery Eliminator
2 Banana Plug
2 Press down the top area of the battery eliminator into the compartment until it clicks.
3 Remove the retainer by loosening the thumb screw.
WARNING:
Use the right RF cable kit for testing, else it damages the RF connector.
• RF Cable Kit TL000100A01 for RF testing.
• RF Cable Kit TL000068A01 for GPS testing.
4 Align the RF Cable Kit into the RF slot.
5 Insert the RF Cable Kit into the RF slot. A slight friction is felt when the RF Cable Kit is
connected to the RF switch located inside the radio.
6 Push the RF plug deeper into the slot until it reached maximum depth.
7 Reassemble the retainer and tighten the thumb screw.
MN002952A01-AH
Chapter 4: Test Setup and Testing
35