5.7.3.1
Attaching the Main Seal
Procedure:
Follow the sequence in Figure 32: Attaching the Main Seal on page 81 to insert the retention
features of the main seal into the respective slots of the front housing.
Figure 32: Attaching the Main Seal
No. Description
1 Installation sequence
2 Black tape
3 Retention features
5.7.3.2
Installing the OLED Display Module Assembly
Procedure:
1 Insert the OLED rubber jacket tabs into the slots on the front housing to assemble the OLED
capacitive touch proximity module assembly.
Figure 33: Installing the OLED Display Module Assembly
No. Description
1 Rubber jacket tabs
2 Press down the OLED capacitive touch module and the OLED display module assemblies to
ensure that they are in place.
3 Insert the capacitive touch metal retainer and press it down firmly until it snaps in place below
the plastic retention feature of the front housing.
MN002952A01-AH
Chapter 5: Maintenance
81
To Next Page
Loading...
