Figure 41: Attaching the USB Flex Board-to-Board Connector
5.7.3.6
Installing the Front Cover
Procedure:
1 Attach the OLED display board-to-board connector to the main display board-to-board
connector.
Figure 42: Attaching the OLED Display Board-to-Board Connector
2 Align the bottom edges of the front cover and the main housing. Press down on the top area of
the front cover to attach it to the two catches on the main housing.
Figure 43: Attaching the Front Cover
3 Follow the sequence in Figure 44: Attaching the Main Screws on page 85 to fasten the screws.
Use a torque screwdriver with 6 IP Torx Plus bit and screw in a clockwise direction.
MN002952A01-AH
Chapter 5: Maintenance
84
To Next Page
Loading...
