Motorola ST7000 - Removing the Front Cover; Figure 15: Removing the Battery; Figure 16: Removing the Main Screws; Figure 17: Removing the Front Cover

Figure 15: Removing the Battery
5.7.2.4
Removing the Front Cover
Procedure:
1 Follow the sequence in Figure 16: Removing the Main Screws on page 76 to remove the
screws. Use a torque screwdriver with 6 IP Torx Plus bit and unscrew in a counterclockwise
direction.
Figure 16: Removing the Main Screws
2
3 5 1
6 4
2 Take note of the two catches in Figure 17: Removing the Front Cover on page 76. Release the
catches one at a time by pulling the front cover toward the bottom of the radio while lifting
upward. A significant amount of force may be required to release the catches, but do not lift the
front cover completely as a flex is attached to it.
Figure 17: Removing the Front Cover
1
No. Description
1 Catches
3 Detach the OLED Display Flex board-to-board connector.
MN002952A01-AH
Chapter 5: Maintenance
76