Moxa Technologies AirWorks AWK-1137C User Manual

AirWorks AWK-1137C Web Console Configuration
3-24
Transmission rate
Setting Description Factory Default
Auto The AWK-1137C senses and adjusts the data rate
automatically
Auto
Available rates Users can manually select a target transmission data rate but
does not support when RF type are G/N mixed, B/G/N mixed
and A/N mixed.
Minimum transmission rate
Setting Description Factory Default
0 to 64 Mbps
(0 to disable)
By setting a minimum transmission rate, the AWK-1137C will
avoid communicate with weak signal wire
less links to maintain
overall wireless performance and optimize the wireless
frequency usage.
0 (Disable)
Transmission power
Setting Description Factory Default
Available power Users
can manually select a target power to mask max output
power. Because different transmission rates would have their
own max output power, please reference product datasheet.
For 802.11bg, the available setting is from 0 to 20
20 dBm
Fragmentation threshold
Setting Description Factory Default
Fragment Length
(256 to 2346)
S
pecifies the maximum size a data packet before splitting and
creating another new packet
2346
RTS threshold
Setting Description Factory Default
RTS/CTS Threshold
(32 to 2346)
D
etermines how large a packet can be before the Access Point
coordinates transmission and reception to ensure efficient
communication.
2346
NOTE
You can refer to the related glossaries in
Appendix A for detailed information about the above-mentioned
settings. By setting these parameters properly, you can better tune the performan
ce of your wireless network
.
Antenna
Setting Description Factory Default
A/B/Both Specifies the output antenna port. Setting “Antenna” to Auto
allows 2x2 MIMO communication under 802.11n and 2T2R*
communication in legacy 802.11a/b/g modes.
Both
*Different from 802.11n’s multiple spatial data stream (2x2 MIMO), which doubles the throughput, 2T2R
transmits/receives the same piece of data on both antenna ports.
WMM
Setting Description Factory Default
Enable/Disable WMM is a QoS standard for WLAN traffic.
Voice and video data
will be given priority bandwidth when enabled with WMM
supported wireless clients.
NOTE: WMM will always be enabled under 802.11n mode.
Enable
Turbo Roaming
Setting Description Factory Default
Enable/ Disable Moxa’s Turbo Roaming can enable rapid handover when the
AWK-1137C, as a client, roams among a group of APs.
Disable

Moxa Technologies AirWorks AWK-1137C Specifications

General

Brand	Moxa Technologies
Model	AirWorks AWK-1137C
Category	Wireless Access Point
Language	English