AirWorks AWK-1137C Web Console Configuration
Max No. of connection
Setting Description Factory Default
1 to 2 This field specifies the maximum number of connections that
will be accepted by the serial port.
1: Only a single host may open the TCP connection to the serial
port.
2: This serial port will allow the specified number of connections
to be opened simultaneously. When multiple connections are
established, serial data will be duplicated and sent to all
connected hosts. Data from hosts will be sent to the attached
serial device on a first-in-first-out basis.
1
Ignore Jammed IP
This field specifies how an unresponsive IP address is handled when there are simultaneous connections to the
serial port.
Setting Description Factory Default
Disable All transmission will be suspended if one IP address becomes
unresponsive. Transmission will only resume when all hosts
have responded.
Disable
Enable Data transmission to the other hosts will not be suspended if
one IP address becomes unresponsive.
Allow Driver Control
This field specifies how the port will proceed if driver control commands are received from multiple hosts that
are connected to the port.
Setting Description Factory Default
Disable Driver control commands will be ignored. Disable
Enable Control commands will be accepted, with the most recent
command received taking precedence.
TCP Port
Setting Description Factory Default
0 to 9999 This field spec
ifies the TCP port number that the serial port will
use to listen to connections, and that other devices must use to
contact the serial port.
4001
Cmd Port
Setting Description Factory Default
0 to 9999 This field specifies the TCP port number for listening to SSDK
commands from the host.
966
When the connection goes down
This field specifies what happens to the RTS signals when the Ethernet connection goes down. For some
applications, serial devices need to know the Ethernet link status through RTS signals sent through the serial
port.
Setting Description Factory Default
always low The selected signal will change to low when the Ethernet
connection goes down.
always high
always high The selected signal will remain high when the Ethernet
connection goes down.
To Next Page
Loading...
