AirWorks AWK-1137C Web Console Configuration
TCP/UDP Port Filters
The AWK-1137C’s TCP/UDP port filter is a policy-based filter that can allow or filter out TCP/UDP-based packets
with a specified source or destination port.
The AWK-1137C provides 32 entities for setting the range of source/destination ports of a specific protocol. In
addition to selecting TCP or UDP protocol, you can set either the source port, destination port, or both. The end
port can be left empty if only a single port is specified. Of course, the end port cannot be larger than the start
port.
The Application name is a text string that describes the corresponding entity with up to 31 characters.
Remember to check the Active check box for each entity to activate the setting.
TCP/UDP port filters
Setting Description Factory Default
Enables TCP/UDP port filters
Disable
Disable Disables TCP/UDP port filters
Policy
Setting Description Factory Default
Accept Only the packets fitting the entities on list can be allowed. Drop
Drop Any packet fitting the entities on list will be denied.
ATTENTION
Be careful when you enable the filter function:
+ “no entity on list is activated” = all packets are allowed
+ “no entity on list is activated” = all packets are denied
To Next Page
Loading...