NPort IA5150A/IA5250A Series Configuring NPort Administrator
7. The Serial Parameter settings shown here are the default settings when the NPort IA5150A/IA5250A is
powered on. However, the program can redefine the serial parameters to different values after the program
opens the port via API.
8. After setting the COM Mapping, remember to select Apply Change to save the information in the host
system registry. The host computer will not have the ability to use the COM port until after Apply Change
is selected.
9. Select Discard Change to tell Administrator NOT to save the COM Mapping information to the host.
To Next Page
Loading...
