NPort IA5150A/IA5250A Series Configuring NPort Administrator
5. Click OK, and confirm that the serial ports that were assigned. The COM Port column confirms that your
selected ports are labeled as part of a “Group.” You will be able to view the serial ports that were assigned
to and removed from the Group. Click Apply to apply the settings.
6. Finally, click Yes to confirm.
Deleting a COM Group
Follow the steps below to delete a COM Group and then auto-assign COM numbers for each port in the Group:
1. Select all serial ports in the Group you are deleting and then right-click to select COM Settings.
To Next Page
Loading...
