USER MANUAL
compact
MRU GmbH, D-74172 Neckarsulm
11.4. Using the USB-Port
This port is used for data transfer from your analyzer to your PC / Laptop using the MRU Online
View (Version 2.XX). The first time you want to use your analyzer for data transfer to your PC or
laptop, you have to “mate” the analyzer and your PC / Laptop. (Requires operating system
Windows XP or Windows 7).
Your PC / Laptop will recognize the analyzer as USB- HID (Human Interface Device).
Check list:
• Switch on the analyzer
• Connect the USB cable to the analyzer
• Connect the USB cable into a free USB port at your PC/Laptop
• The PC/Laptop must be powered on
• The above seen information „New hardware found“ will be displayed above the USB-Icon of
your PC/Laptop
If this is not the case, then you have a problem with your USB-Connection of your PC/Laptop.
Check in your Device Manager if the analyzer is ready for operation.
The analyzer is as HID-conform unit registrated.
Windows XP: Press the START button – then select the CONTROL PANEL – select SYSTEM –
select HARDWARE – select DEVICE MANAGER
Windows 7: for Windows 7 there are several possibilities, please read your Windows 7 manual
for details.
(The graphics may look different on your PC/Laptop as shown in this manual!)
To Next Page
Loading...
