EasyManua.ls Logo

MSA ALTAIR 5X - 2.8 Monitoring Combustible Gases

MSA ALTAIR 5X
91 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MSA
Description
ALTAIR 5X/ALTAIR 5X IR
30
GB
2.8 Monitoring Combustible Gases
The device can be equipped with a catalytic combustible sensor that detects a va-
riety of combustible gases up to 100 % LEL and displays the reading as either
%LEL or %CH
4
. The ALTAIR 5X IR can also contain an IR combustible sensor.
The IR sensor displays the reading in % Vol.
The catalytic combustible and the 25 % Vol Butane IR sensor have two alarm set-
points:
-HIGH Alarm
- LOW Alarm
If the gas concentration reaches or exceeds the alarm set point, the device:
- alarm message displays and flashes in combination with the corresponding gas
concentration:
- backlight turns on
- alarm sounds [if active]
- alarm LEDs flash [if active]
The 100 % Vol IR sensors have no alarm setpoints.
Gas Exposure of 100 % LEL
For ALTAIR 5X IR devices with an enabled 100 % Vol methane IR sensor, the
LockAlarm will clear, and the catalytic combustible again displays combustible con-
centrations when the gas sample drops to a lower level. For devices without an en-
Attention!
If an alarm is triggered while using the device, leave the area
immediately.
Remaining in the area under such circumstances can cause serious
personal injury or death.
When gas reading exceeds 100 % of the lower explosive limit [LEL],, the
device enters a Lock Alarm state and displays “XXX” in place of the ac-
tual reading.
Attention!
A catalytic combustible gas reading of "XXX” indicates the atmosphere
could be above 100 % LEL or 5.00 % Vol CH
4
and an explosion hazard
exists. Move away from contaminated area immediately.

Other manuals for MSA ALTAIR 5X

Related product manuals