MSA ALTAIR 5X - 1.2 Liability Information

Safety RegulationsMSA
ALTAIR 5X/ALTAIR 5X IR
GB
7
- Have a trained and qualified person interpret device readings.
- Do not remove battery pack from device while in a hazardous location.
- Do not recharge Li Ion battery in a combustible location.
- Do not replace alkaline batteries in a combustible location.
- Do not alter or modify device.
- Use only MSA-approved sampling lines.
- Do not use silicone tubing or sampling lines.
- Wait sufficient time for the reading; response times vary, based on gas and
length of sampling line.
- Do not use the device with integral pump for prolonged periods in an atmos-
phere containing a concentration of fuel or solvent vapours that may be greater
than 10 % LEL.
It is imperative that this operating manual be read and observed when using the
product. In particular, the safety instructions, as well as the information for the use
and operation of the product, must be carefully read and observed. Furthermore,
the national regulations applicable in the user's country must be taken into account
for a safe use.
Alternative use, or use outside this specification will be considered as non-compli-
ance. This also applies especially to unauthorised alterations to the product and to
commissioning work that has not been carried out by MSA or authorised persons.
1.2 Liability Information
MSA accepts no liability in cases where the product has been used inappropriately
or not as intended. The selection and use of the product are the exclusive respon-
sibility of the individual operator.
Product liability claims, warranties also as guarantees made by MSA with respect
to the product are voided, if it is not used, serviced or maintained in accordance with
the instructions in this manual.
Danger!
This product is supporting life and health. Inappropriate use, mainte-
nance or servicing may affect the function of the device and thereby se-
riously compromise the user's life.
Before use the product operability must be verified. The product must
not be used if the function test is unsuccessful, it is damaged, a compe-
tent servicing/maintenance has not been made, genuine MSA spare
parts have not been used.