MSA ALTAIR 5X - 3.2 Turning ON and Fresh Air Setup

OperationMSA
ALTAIR 5X/ALTAIR 5X IR
GB
33
3.2 Turning ON and Fresh Air Setup
Device operation is dialog driven from the display with the aid of the three function
buttons [→ chapter 2.2].
For more information, see the flow charts in chapter 7.
Turn the device ON with the ON/OFF button.
The device performs a self test:
During the self test, the device checks alarm LEDs, audible alarm vibrating alarm
and installed sensors.
The device displays:
- Startup logo
- Software version, device serial number, company name, department and user
names
- Sampling system safety test
During the turn-ON sequence, if a sensor was changed since the previous device
operation, the current listing of the installed sensors displays and user interaction
is required.
 The user must accept the new configuration by pressing the  button.
 If the current sensor configuration is not accepted, the device alarms and is
not usable.
- Combustible gas type and sensor units [monochrome display only]
- Alarm setpoints Low Alarm
- Alarm setpoints High Alarm
- Alarm setpoints STEL Alarm [if enabled]
- Alarm setpoints TWA Alarm [if enabled]
- Settings for calibration cylinder
- Current date
- Last calibration date [optional]
- CAL due date. If the calibration due date is activated, the message "CAL DUE;
X DAYS" appears on the device display.