MSA Toxgard II User Manual

b. Screw the Flow
Controller onto
the top of the
zero gas
cylinder.
c. Locate the Tube
Assembly
(P/N 711112).
d. Push the smaller
end of the Tube
Assembly over
the Flow
Controller
gas outlet.
• Ensure
tubing
completely
covers the gas outlet (FIGURE 3-7).
e. Connect the other end of the tubing
over the SensorGard inlet (FIGURE 3-8).
f. Turn on the gas flow by turning the knob on the
flow controller.
• Notice the open arrow on the flow controller knob.
Figure 3-7.
Calibration Tubing Set-up
Figure 3-8.
Zero Gas Connection
Chapter 3, Calibration
3-9

MSA Toxgard II Specifications

General

Brand	MSA
Model	Toxgard II
Category	Monitor
Language	English