GB
MSA DECLARATION OF CONFORMITY
ULTIMA
®
X
3 TM
3-1
Declaration of conformity
Manufactured by:
Mine Safety Appliances Company
1000 Cranberry Woods Drive
Cranberry Township, PA 16066 USA
The manufacturer or the European Authorized Representative:
MSA AUER GmbH, Thiemannstraße 1, D-12059 Berlin
declares that the product: MSA ULTIMA
®
XE / X
3 TM
based on the EC-Type Examination Certificate:
DMT 02 ATEX E 202 X
complies with the ATEX directive 94/9/EC, Annex III. Quality Assurance Notification
complying with Annex IV of the ATEX Directive 94/9/EC has been issued by INERIS
of France, Notified Body number: 0080 .
The product is in conformance with the EMC directive 89/336/EC, changed by
Directive 91/263/EC, 92/31/EC, 93/68/EC, with the following harmonized norms or
normative documentation:
EN 50 270 Type 2* EN 61 000 - 6 - 3
* EN 61000-4-6: occasional transmission error can appear.
A fault check has to be used at the receiver unit.
We further declare that the product complies with the provisions of LVD
Directive 73/23/EC as amended by Directives 93/68/EC, with the following
harmonized norms or normative documentation:
EN 61 010
MSA AUER GmbH
Dr. Axel Schubert
R & D Instruments
Berlin, February 2007
To Next Page
Loading...
