Discharge Chute and Controls (Joystick, Hex Shaft)
109
11. Separate the Remote Head from the chute. See Fig-
ure 10.10.
NOTE: There is a flat washer between the Remote Head
and the chute. If this washer is missing, the
Remote Head may bind up. See Figure 10.11.
12. Move the Remote Head and cable to a workbench for
service.
13. Remove the four screws that hold the Gear Support
to the cover using a 5/16” wrench. See Figure 10.12.
Figure 10.10
Separate here
To Next Page
Loading...
