Medium Frame 2 & 3 Stage Snow Throwers
110
14. Lift the Gear Support out of the cover enough to
unhook the cable from the lock. See Figure 10.13.
15. Remove the Gear Set from the cover
NOTE: If the cable or housing is to be replaced, dis-
connect it from the Remote Head Housing.
See Figure 10.14.
16. Pivot the Latch Pawl away from the Pinion Gear,
then slip the Pinion Gear out of the bushing that
supports it. See Figure 10.15.
Figure 10.15
Latch Pawl
Pinion Gear
To Next Page
Loading...
