Configuring the reverse driving sensor
"Simulated speed" function
Entering the number of nozzles per section
Switching sections off permanently
Permanently switching off a section using a sensor
System delay when switching the sections
Configuring the nozzles - for field sprayers with pressure sensor regulation
Configuring the extremity nozzles
Operating the extremity nozzles
Vario and Select mode - configuring multiple nozzle holders
Before you buy nozzles - check the possible application rates
Vario mode - Automatic nozzle selection
Select mode - Manual nozzle selection
Configuring the nozzles on the multiple nozzle holder
Selecting the type of nozzle
Deactivating nozzles globally
Excluding nozzles from Vario mode
Activating the multiple nozzle holder
Entering the field sprayer geometry
Calibrating the sensors for reproducing the boom slope
Field sprayer with two circulations and job computers
Identifying the job computer
Geometry on a field sprayer with two job computers
Configuring TRAIL-Control
Adjusting the configuration to the tractor
Calibrating TRAIL-Control
Teaching-in the central position and limit stops
Calibrating the hydraulics of the proportional valve
Configuring the automatic centering
Centering when exceeding the maximum speed
Centering when switching to manual mode
Centering when tapping the centering icon
Configuring automatisms when driving in reverse
Reaction to the reverse driving signal in manual mode
Reaction to the reverse driving signal in automatic mode
TRAIL-Control – Using drawbar and stub axle steering
Steering the trailed implement
To Next Page
Loading...
Need help?
General
