Configuring the job computer
Vario and Select mode - configuring multiple nozzle holders
Deactivating nozzles
You can only deactivate nozzles on a quadruple nozzle holder.
The following options are available to you:
▪ You can deactivate a nozzle globally.
▪ You can also exclude a nozzle in Vario mode. In die
Deactivating nozzles globally
Deactivate nozzles in this way if you are using a nozzle holder that is not fully equipped.
The nozzle is installed on a quadruple nozzle holder.
The "MULTI NOZZLES" screen is called up.
1. Use the cursor to select the nozzle to be deactivated.
⇨ A list of nozzle colors appears.
2. Select "No nozzle".
Excluding nozzles from Vario mode
You can also exclude a nozzle from Vario mode. The excluded nozzles can only be activated in
Select mode or in cleaning mode.
In this way, for example, you can use the nozzle deactivated in Vario mode for the application of
liquid fertiliser in Select mode. The remaining 3 nozzles remain available for normal spraying in Vario
mode.
The nozzle is installed on a quadruple nozzle holder.
The "MULTI NOZZLES" screen is called up.
1. - Press.
2. to - Select the nozzle to be excluded.
3. The excluded nozzle will be marked as follows:
Activating the multiple nozzle holder
To activate the Vario license:
1. Switch to the "PARAMETERS" screen:
> > >
2. - Open the license menu.
⇨ The "LICENCES" screen appears.
3. Select "MULTI NOZZLES".
4. Copy the "ME code" and use it it when purchasing the license from Müller-Elektronik. You will
receive a password from Müller-Elektronik for the activation of the function.
To Next Page
Loading...
Need help?
General
