TRAIL-Control
TRAIL-Control – Using drawbar and stub axle steering
When you activate the 'slope counter-steering' function, you can offset the track of the trailed
implement to the left or right. The direction in which the track is offset depends on if the slope climbs
or declines to the left or right of the implement.
The aim of the "slope counter-steering" function is to prevent the trailed implement from driving
inclined to the direction of work on a slope.
Steering the trailed implement against the slope
TRAIL-Control with stub axle steering
TRAIL-Control with drawbar steering
Slope countersteer
Degree of the slope. Measured by the slope sensor.
On level ground, the icon must appear here when the function is activated. If this is not the
case, the slope sensor is not calibrated.
The slope sensor is calibrated during the TRAIL-Control calibration. Repeat this calibration when the
slope sensor has to be calibrated.
Steering direction of the system. While driving, the system steers the trailed implement against the
slope until the desired angle is achieved. Then the arrow is no longer displayed.
To activate the "Slope counter-steering" function:
1. Switch to the "TRAIL-Control" screen:
>
or
>
To Next Page
Loading...
Need help?
General
