Operating job computer on the field
Tank filling
Operating job computer on the field
Tank filling
After each fill-up of the spray liquid tank, you enter how much water you added.
Depending on what additional equipment is fitted to your field sprayer, the process may be different.
In doing so, you can:
▪ Filling up the tank manually without additional systems
▪ Filling up the tank with TANK-Control
▪ Filling up the tank with TANK-Control and with fill stop
Filling up the tank manually without additional systems
If you fill up the tank manually without any additional systems, you need to enter the new tank content
manually on the terminal.
Tank was fully filled up.
Set tank content to 0 liter.
To enter the new tank content when you have completely refilled the spray liquid tank:
1. Switch to the “Filling - manual ” screen:
⇨ The following screen appears:
2. - Enter full tank
or
3. In the “New tank content” box, enter the tank content after refilling.
⇨ The new tank content appears in the work screen, in the tank data area.
Filling up the tank with TANK-Control
TANK-Control is a measurement system that constantly measures and displays the tank content.
To Next Page
Loading...
Need help?
General
