Operating job computer on the field
Starting application
4. Turn only when the boom is horizontal.
5. - Press once after the turning manoeuvre.
⇨ The job computer slopes the boom in the opposite direction until the previously saved angle
is reached on the other side.
⇨ While the boom is moving, a green arrow appears on the work screen.
⇨ The function switches off if you change the boom angle manually.
Starting application
To start the application:
The tractor with the field sprayer is on the field.
You have configured the job computer.
You have folded out the boom.
1. Ensure that all prerequisites have been fulfilled.
2. - Start application
⇨ In manual mode:
The field sprayer starts the application.
Spray cones appear under the boom icon:
⇨ In automatic mode:
The field sprayer will be prepared for application.
As long as the field sprayer does not move, the following icon appears in the work screen:
3. In automatic mode:
Start driving and exceed the minimum speed for the automatic regulation (parameter:
“Regulation off below”).
⇨ As soon as the minimum speed is exceeded, the field sprayer starts the application.
Spray cones appear under the boom icon:
⇨ You have started application.
There may be situations where you want to start spraying while the sprayer is still at a standstill. For
example, when you have stopped on the field.
To start immediate application in automatic mode:
The tractor with the field sprayer is on the field.
You have configured the job computer.
You have folded out the boom.
To Next Page
Loading...