9
Virtual ECU application
Parameters
▪ Sprayer
▪ Soil tillage
Connector type
Use this parameter to define the connector type of the agricultural implement.
The following connector types are possible:
▪ Unknown
▪ Drawbar
▪ 3-point hitch mounted
▪ 3-point hitch semi-mounted
▪ Hitch hook
▪ Clevis coupling
▪ Piton-type coupling
▪ CUNA hitch
▪ Ball-type hitch
Machine model
This parameter influences how the working bar follows the arrow in TRACK-Leader. The
configuration improves the precision of the recording of applied areas in curves.
After each change, you also need to adjust the geometry.
Potential values:
▪ "mounted"
Setting for implements that are mounted on the tractor three-point hitch.
▪ "trailed"
Settings for implements trailed by a tractor. The working bar is guided like a trailer behind a
tractor.
Swath width
This parameter shows the swath width set for an ag equipment.
No. of sections
Enter the number of sections that can be switched off on the implement. On a field sprayer, they are
the section valves; on a fertilizer spreader or a planter/seeder, they can be e.g. metering units.
This parameter serves to transmit the proper number of sections to the SECTION-View module, so
that you can switch the sections manually.
Each section appears as part of the working bar on the screen.
Sections
Opens a screen where you can enter the width of the individual sections on the implement.
Geometry
The geometry contains a series of dimensions that help to properly display the vehicle-implement
combination in TRACK-Leader and determine its position.
To Next Page
Loading...
Need help?
General