User Manual
10. Appendix
Appendix A: Enclosure
Standard Accessories:
A pair of Passive probe: 1.2 m, 1:1 (10:1)
1 x CD (PC link application software)
1 x Power cord: up to the standards of the country in which it is used.
1 x USB cable
1 x Quick Guide
Appendix B: General Care and Cleaning
General Care
Do not store or place the instrument in locations where the liquid crystal display (LCD)
may be directly exposed to the sunshine for long periods.
Be careful: Do not spray liquid into the instrument.
Cleaning
Inspect the instrument and the probe frequently in accordance with operating conditions.
Clean the outer surface of the instrument according to the following steps:
1. Wipe off the floating dust outside of the instrument and the probe by using soft
cloth. When cleaning the LCD, do not scratch the transparent LCD protective
screen.
2. Wipe the instrument in power off status by soft cloth that is lightly moistened. Use
only mild detergent and fresh water. Do not use any abrasive chemicals to avoid
the instrument or the probe being damaged.
Warning: Before running, please confirm that the instrument has been dried
out so as to avoid electrical short circuit and personal injury caused
by moisture.
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF ELECTRICAL &
ELECTRONIC EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste Electrical & Electronics
Equipment (WEEE). Any WEEE marked products must not be mixed with general household waste,
but kept separate for the treatment, recovery and recycling of the materials used. Contact your local
authority for details of recycling schemes in your area.
Made in China
LS12 2EN
To Previous Page
Loading...
Need help?
General
