User Manual
● LAN Set
Using the LAN port, the oscilloscope can be connected with a computer directly, or
through the router to connect. The network parameters can be set in the menu below.
Refer to "Using LAN Port" on P83 for the operation steps.
Press the Utility button and turn the M rotary control to select the LAN Set to go to the
following menu.
Figure 5-66 LAN Set menu
The description of LAN Set menu is shown as the follows:
How to Measure Automatically
Press the Measure button to display the menu for the settings of the Automatic
Measurements. At most 8 types of measurements could be displayed on the bottom left
of the screen.
The oscilloscopes provide 24 parameters for auto measurement, including Period, Freq,
Mean, PK-PK, RMS, Max, Min, Vtop, Vbase, Vamp, OverShoot, PreShoot, Rise Time,
Fall Time, +D width, -D width, +Duty, -Duty, Delay A→B , Delay A→B , Cycle
RMS, Cursor RMS, Duty cycle, and Phase.
The menu is displayed as Figure 5-67.
Press F1 button to switch between each byte, turn the M rotary
control to change value (0 - 255)
Turn the M rotary control to change value (0 - 4000)
Press F3 button to switch between each byte, turn the M rotary
control to change value (0 - 255)
Press F4 button to switch between each byte, turn the M rotary
control to change value (0 - FF)
Press F5 button to switch between each byte, turn the M rotary
control to change value (0 - 255)
Save the current settings and prompt "reset to update the config"
To Next Page
Loading...
Need help?
General
