58 Part Number 9294699 12/16/15
Maintenance Section 4
Sanitize Lines
1. DO NOT ALLOW CLEANING MANIFOLD TO TOUCH
THE FLOOR.
2. Remove cleaning manifold from bucket #2 - Warm
Rinse Water and place into bucket #3 - Sanitizer.
3. Ensure each of the manifold tubes are connected.
4. Press Green Check to continue and begin rinse. As
Rinse solution runs through each line, the display will
change from Washed to Rinsed and turn green.
This will automatically send the sanitizing solution through
each line (slot) that was selected, displaying the progress on
the screen, 30 seconds per slot.
When sanitizing has completed, the Purging Instructions
screen will appear automatically.
Purging Lines
1. Disconnect the cleaning hoses from the white nozzles.
2. Press Green Check to continue and purge the lines. Air
is pushed through each line blowing out any remaining
liquid. The line on the display will change from
Sanitized to Purged and turn green.
Air is pushed through each line (slot) that was selected,
blowing out any remaining liquid, displaying the progress
on the screen, 30 seconds per slot.
When purging has completed, the Reinstall Inventory
screen will appear automatically.
3
2
3
To Next Page
Loading...
Need help?
General
