MULTIQUIP Rammax RX1575 - Page 94

PAGE 94 — RX1575 SERIES TRENCH ROLLER • OPERATION MANUAL S/N 3069933~ — REV. #0 (11/29/23)
MAINTENANCE
104 RAMMAX1575
555081
557016
3.6 Individual Operations of Maintenance
3.6.16 Replacement of engine oil and lter
First carry out after 50 hours.
Draining engine oil
• The engine oil drain (1) is located under the chassis at the
front left.
• Place acontainer under the drain.
• Open the union by turning it anti-clockwise (size 27 wrench).
• The oil starts to ow out immediately.
Replacement of engine oil lter
• Loosen the lter (1) by hand or using alter wrench.
• The oil starts to ow out immediately. It’s best to place arag
under it beforehand.
• Replace oil lter.
• Install in accordance with instructions (see lter packaging
or lter housing).
• Screw the complete lter back in place.
Engine oil lter
Order number: 1-954075
Note
After relling, start the engine for 2 - 3 min. Check tightness of
drain plug and lter.
Stop the engine, wait for approx. 5 min. until oil runs down to
the engine sump. Then check the level with oil dipstick.