Multitech MultiConnect rCell 100 - Page 87

DEVICE ADMINISTRATION
MultiConnect
®
rCell 100 MTR-EV3 User Guide 87
1. Check Enabled.
2. Enter the Duration in seconds.
3. Under Notification Options, select the recipients from the drop-down in Recipient Group.
4. In Notify, enter the frequency of notification (in hours). Default is 24.
5. Select how you want to send alerts by clicking Email, SMS or SNMP.
6. Click Finish.
7. To save your changes, click Save and Restart.
For Cellular Interface Failure:
1. Check Enabled.
2. Enter the Duration in seconds.
3. Under Notification Options, select the recipients from the drop-down in Recipient Group.
4. In Notify, enter the frequency of notification (in hours). Default is 24.
5. Select how you want to send alerts by clicking Email, SMS or SNMP.
6. Click Finish.
7. To save your changes, click Save and Restart.
For Ethernet Data Traffic:
1. Check Enabled.
2. Enter Interval in hours when alert is sent.
3. Under Notification Options, select the recipients from the drop-down in Recipient Group.
4. In Notify, the constant value is Always.
5. Select how you want to send alerts by clicking Email, SMS or both.
6. Click Finish.
7. To save your changes, click Save and Restart.
For Cellular Data Traffic:
1. Check Enabled.
2. Enter Interval in hours when alert is sent.
3. Under Notification Options, select the recipients from the drop-down in Recipient Group.
4. In Notify, the constant value is Always.
5. Select how you want to send alerts by clicking Email, SMS or both.
6. Click Finish.
7. To save your changes, click Save and Restart.
For WAN Interface Failover:
1. Check Enabled.
2. Enter the Timeout in seconds.
3. Select what to Notify On from the drop-down.
4. Under Notification Options, select the recipients from the drop-down in Recipient Group.
5. In Notify, the constant value is Always.
6. Select how you want to send alerts by clicking Email, SMS or SNMP.