Chapter 3 – Installing Software
MultiVOIP® Voice/Fax over IP Gateways 27
To set Interface Parameters:
1. From the Channel drop down list, select Channel whose parameters you want to configure.
2. From the Interface Type drop down list, select FXS, FXO, E&M or DID (FXS/FXO only for –SS and –FX series)
3. From the Regeneration group, select how signal is regenerated; as Pulse or DTMF
4. In the Inter Digit Timer field, type time the MultiVOIP waits between digits.
5. From the Message Waiting Indication drop-down list, for E&M only select Light or None.
6. In the Inter Digit Regeneration Timer field, type time between sent DTMF digits.
7. In the Flash Hook Options group:
● Generation (used in conjunction with FXO/E&M)
● Detection Range (used in conjunction with FXS/E&M)
8. In the Caller ID group:
● Bellcore is the only option available
● CallerID Manipulation is available if needed
● CID Manipulation is not available in the –SS models
9. In the FXS Options group:
● In the Ring Count field, type the number of rings allowed before call abandoned; default is 8.
● Check Use Current Loss if you want the MultiVOIP to interrupt current to disconnect.
● Check Generate Current Reversal if you want to activates Answer/Disconnect Supervision to FXO.
10. In the FXO Options group:
● In the Ring Count field type the number of rings before MultiVOIP answers.
● In the No Response Timer field, type the time to attempt call before abandoning.
11. Click Supervision to set call answering and disconnection settings.
a. Complete Answer fields:
• Current Reversal (use current reversal to answer)
• Answer Delay
• Answer Delay Timer (in seconds)
• Tone Detection (allow tone sequence to disconnect)
• Available Tones
• Answer Tones (shows current selection from Available Tones)
To Next Page
Loading...
