Munters Trio Poultry Controller - Mapping and Defining the Input Output Devices; Mapping Devices

© Munters AB, 2020 44
7 Mapping and Defining the Input Output
Devices
NOTE Munters recommends that a trained technician perform the following operations.
• Mapping Devices
• Temperature Sensors
• Ventilation Devices
• Sensors
• Heating Devices
• Defining the Cooling Devices
• Inlets, Tunnel Doors, Outlets
• Defining the Same As Relays
• Defining the Same As Analog Ports
• Defining the Timer
• Defining the Auxiliary Input
• Lighting Devices
• Feeding Devices
• Defining the Silos
• Defining the Bird Scales
• Defining the RSU
• Defining the Trio RPS
7.1 Mapping Devices
After wiring devices to the Trio, each device must be mapped and then defined. Mapping and defining
devices enables the system software to control each device’s functionality.
CAUTION Mapping MUST match the physical wiring! An error message appears if the physical device
is not wired to the relay or port as defined on the mapping screen..