Munters Trio Poultry Controller Installation Manual

© Munters AB, 2020 59
7.5 Heating Devices
 Define up to six relays and/or analogue output ports as heaters (refer to Mapping Devices,
page 44).
• Defining the On/Off Heaters
• Defining the Variable Heaters
7.5.1 D
EFINING THE
O
N
/O
FF
H
EATERS
• Define:
o
Zone Heater:
 Disable (default): Central Heaters, the heater output is related to the target
temperature, these heaters operate according to the average temperature (no
temperature sensors can be assigned to it).
 Enable: Zone Heater, the heater output has its own target set-point and its own
sensors assign to it. Zone heater will enable the assignment of temperature
sensor/s in temperature definition.
o
Operation: Define the relay mode.
o
Operation Modes
 Continues (default): The heater starts to operate continuously
 Cycle: This option enables the operation of heater in cycles.

Munters Trio Poultry Controller Specifications

General

Brand	Munters
Model	Trio Poultry Controller
Category	Controller
Language	English