MUTOH ValueCut VC-600 - Wavy Lines and Data Loss

MAINTENANCE MANUAL
VCE-MM-02
54
 Pre-run the media back and forth using the arrow key will help. (Reload the media and pre-run.)
The edge of the media is not straight. (Change the media.)
 Media is too thin. (Change it.)
 Drum is coated with paper chips or dust. (Clean the surface of drum.)
 Drum or pinch roller is worn. (Change the drum set or pinch roller.)
The lines quality is wavy.
[Causation and recovery:]
 Forget to fasten the tool fastening screw. (Fasten it.)
 The blade is worn. (Change it.)
 The acceleration is too high. (Set the acceleration to a lower value; please refer to the default
value.)
 The carriage belt tension is incorrect. (Adjust the belt tension.)
 X or Y motor belt tension is incorrect. (Adjust the belt tension.)
 The spring loading bearing of carriage is damaged. (Change the carriage set.)
 The length of the media is too short in X direction. (Change the media.)
 Media is too thin. (Change it.)
 Drum or pinch roller is worn. (Change the drum set or pinch roller.)
 X or Y motor is damaged. (Change it.)
Data loses when plotting.
[Causation and recovery:]
 Memory chip is bad. (Change it.) Main board set is bad. (Change it.)
Fatal error occurs when loading media.
[Causation and recovery:]
 Forget to pull out some media from the media roll. (Pull out some media from the roll before you
start to load media.)
 X motor belt is too tight. (Adjust the belt tension.)
Feel electrostatic discharge.
[Causation and recovery:]
 Power out let does not have ground connection. (Improve it.)