N-Tron 7506GX2 - Save or Reset the Configuration Settings; Show or Set IGMP Configuration

(Revised 2011-07-21) Page 136 of 158
CLI Commands, Continued…
Save or Reset the Configuration Settings
Command Name
config
Description
Save or reset configuration settings
Syntax
config s[ave] | r[eset]
Parameters
save
save current running configuration settings.
reset
reset configuration settings to factory defaults.
Examples
N-TRON/Admin> config save
Save Settings...
Settings have been saved.
N-TRON/Admin> config reset
Resetting to factory defaults...
Load factory default settings [y/n]?y
Keep IP, subnet mask, and gateway addresses [y/n]?y
Keep current user names and passwords [y/n]?y
…
NOTES
Show or Set IGMP Configuration
Command Name
igmp
Description
Show or set IGMP configuration. If no parameters are specified, this command will show
the IGMP configuration (same as -show parameter).
Syntax
igmp [-show] [-status state]
Parameters
-show
Show configuration.
-status state
Set the IGMP status to e(nabled) or d(isabled).
Examples
N-TRON/Admin> igmp –show
IGMP Status : Enabled
IGMP Version : 2
Query Mode : Auto
CIP Querier Status : 2, Active-Auto
Active Querier IP : 192.168.1.250
Router Mode : Auto
Manual Router Ports : (None)
IGMP Number of Groups : 1
IGMP Resource Usage % : 1
N-TRON/Admin> igmp –status disabled
IGMP Status : Disabled
IGMP Version : 2
Query Mode : Auto
CIP Querier Status : 2, Active-Auto
Active Querier IP : 192.168.1.250
Router Mode : Auto
Manual Router Ports : (None)
IGMP Number of Groups : 1
IGMP Resource Usage % : 1
N-TRON/Admin>
NOTES