Nanni N4.40 - Check and Maintenance

GENERAL
03-M-E3B, 03-M-DI-E3B, 03-M-E3BG, WSM
G-8
4. CHECK AND MAINTENANCE
[1] DAILY CHECK POINTS
Check of Engine Oil Level
1. Make the engine level.
2. Pull out the dipstick (1) and clean it.
3. Put in and pull it out again.
Make sure that the oil level is between the 2 notches.
4. If the level is too low, add new oil to the specified level.
IMPORTANT
• When you use an oil of different brand or viscosity from the
previous, drain the remaining oil. Do not mix 2 different
types of oil.
NOTE
• When you examine the engine oil level, make sure that you
put it in a level position. If not, you cannot measure oil
quantity accurately.
• Make sure that you keep the oil level between the upper and
lower lines of the dipstick. Too much oil can decrease the
output or cause too much blow-by gas. On the closed
breather type engine, the port absorbs the mist and too
much oil can cause oil hammer. But if the oil level is not
sufficient, the moving parts of engine can get a seizure.
M00000003GEG0008US1
(1) Dipstick (a) Upper Line
(b) Lower Line
KiSC issued 06, 2009 A