Nanni N4.40 - Replacement of Oil Filter Cartridge

GENERAL
03-M-E3B, 03-M-DI-E3B, 03-M-E3BG, WSM
G-11
Replacement of Oil Filter Cartridge
CAUTION
• Make sure that you stop the engine before you replace the
oil filter cartridge.
1. Remove the oil filter cartridge (1) with the filter wrench.
2. Apply a thin layer of oil on the new cartridge gasket.
3. Install the new cartridge by hand. Do not tighten too much
because it can cause deformation of the rubber gasket.
4. After you replace the cartridge, the engine oil usually decrease
by a small level. Make sure that the engine oil does not flow
through the seal and read the oil level on the dipstick.
5. Fill the engine oil until the specified level.
IMPORTANT
• To prevent serious damage to the engine, use only
KUBOTA genuine filters or its equivalent.
M00000003GEG0011US1
(1) Oil Filter Cartridge
KiSC issued 06, 2009 A