GENERAL
03-M-E3B, 03-M-DI-E3B, 03-M-E3BG, WSM
G-9
Check of Coolant Level and Replenishment
• Do not remove the radiator cap when the engine is hot.
Then loosen the cap slightly to release unwanted pressure
before you remove the cap fully.
1. Without recovery tank
Remove the radiator cap (1) and make sure that the coolant
level is immediately below the port.
With recovery tank (2)
Make sure that the coolant level is between FULL A and LOW
B.
2. If the coolant level is too low, find out the cause that there is less
coolant.
Case 1
If the coolant decreases by evaporation, add only clean and soft
water.
Case 2
If the coolant decreases by leak, add coolant of the same
manufacturer and brand in the specified mixture ratio (clean,
soft water and L.L.C.). If you cannot identify the coolant brand,
drain all the remaining coolant and add a new brand of coolant
mix.
• When you add the coolant, release the air from the engine
coolant channels. The engine releases the air when it
shakes the radiator upper and lower hoses.
• Make sure that you close the radiator cap correctly. If the
cap is loose or incorrectly closed, coolant can flow out and
the engine can overheat.
• Do not use an anti-freeze and scale inhibitor at the same
time.
• Do not mix the different type or brand of L.L.C..
M00000003GEG0009US1
(1) Radiator Cap
(2) Recovery Tank
A : FULL
B : LOW
To Next Page
Loading...
Need help?
General
