2. Press Button 2 to select PERFORM.
On the right display you see the available Scene Sync values. The current value is high-
lighted and the corresponding pad is lit. The default value SCENE means that the next
time you select a new Scene or loop range for playing, the switch will happen once the
current Scene has played to the end.
3. Press a pad to select the desired value, for example pad 3 (for 1/4, a quarter note).
→
The next time you select a new Scene or loop range, the switch will happen on the next
quarter note.
To adjust the Retrigger setting:
1. Press and hold SCENE to enter Scene mode (or pin it by pressing SCENE + Button 1).
2. Press the right Page button to Select Page 2/2.
At the bottom left corner of the left display you see the current RETRIGGER value (Off by
default).
Creating a Song Using Scenes
Using Scenes to Play Live
MASCHINE STUDIO - Getting Started - 123
To Next Page
Loading...
Need help?
General
