3. Press Button 1 or Button 2 above the displays to select GROUPS.
By selecting this, a list of Groups will become visible on the right display.
4. Check that Button 4 above the displays is not fully lit and that the USER label underneath
is not highlighted — if necessary, press Button 4 to disable it.
This will now allow us to select only Native Instruments factory content.
5. Turn Knob 5 until Kits is selected, so that only drum kits are shown on the right display.
6. Turn Knob 6 until Urban Kit is selected, this will further reduce the results list on the
right display to the kits of that sub-type.
7. Turn the jog wheel (the bigger knob with a bright LED ring on the right of your controller)
or Knob 8 (under the right display) to scroll down the list until EK-TL A KIT is selected.
First Steps
Loading a Drum Kit from the Factory Library
MASCHINE STUDIO - Getting Started - 23
To Next Page
Loading...
