VS1 Operations and Maintenance Manual Non-standard maintenance
Page 4-4 Issue 3.1 2013-10-01
Installing new software
1. Set the transmitter to RF Off and for Remote control. Perform the following steps remotely
using the AUI on the laptop.
2. Go to the Menu/System Settings/Upgrade Software screen and select the update *.tgz
file from the Select Upgrade Files list (should highlight in blue) and press Start Upgrade.
3. After a successful load (status is 100% complete and a message indicates a successful load),
cycle the ac power (turn off, then on) on the VS1.
4. This completes the software upgrade. Restore the former network settings on the transmitter
and laptop as required (see Step 2 of “Transmitter IP configuration” on page 4-2).
5. Login and repeat Step 1 of “Preliminary checks” on page 4-1 to determine if the current
version is the same as the upgrade version - this confirms the upgrade was successful.
6. If the upgrade was not successful, repeat Step 1 through Step 5. If still unsuccessful, contact
Nautel.
To Next Page
Loading...
