Nautel VS1 - Page 41

VS1 Operations and Maintenance Manual Operating the transmitter
Issue 3.1 2013-10-01 Page 2-13
User Settings - Edit Presets -
Mod Loss
Edit the selected preset’s modulation loss
functionality, such as enable/disable, setting
threshold, setting timeout period, setting resulting
action and selecting a backup preset.
page 2-86
User Settings - Edit Presets -
Audio Delay
Edit the selected preset’s audio delay. page 2-88
User Settings - Edit Presets -
Copy Another Preset
Copy the selected preset’s settings to another
preset.
page 2-88
User Settings - Network Settings View and/or set network information such as MAC
address (view only), DHCP on/off status, IP
address, netmask and gateway.
page 2-111
User Settings - Ext. 10 MHz Inp Enable/disable the use of an external 10 MHz
signal.
page 2-123
User Settings - Set Clock Set precise time and date. page 2-127
User Settings - Pilot Sample Set the pilot sample level for the rear panel BNC
connector.
page 2-133
User Settings - LCD Settings Set the front panel display’s contrast, backlight and
timeout.
page 2-134
User Settings - Signal Gen Enable/disable and setup the internal signal
generator.
page 2-136
User Settings - Station ID Set station ID parameters for re-broadcasting
primary information as a secondary station.
page 2-138
User Settings - FM Mask Select the FM mask - FCC, ETSI or None (turns off
mask).
page 2-140
User Settings - Audio Low Set the low audio thresholds and associated
timeout delays.
page 2-140
User Settings - Turn-On Delay Set the transmitter turn-on delay period. page 2-142
User Settings - Ramp-Up Speed Set the transmitter’s ramp-up speed. page 2-142
User Settings - Remote
I/O
Configure the remote inputs and outputs for the
transmitter.
page 2-151
Table 2.1: Front Panel UI Screens
UI Screen Function See Page