VS1 Operations and Maintenance Manual Operating the transmitter
Page 2-18 Issue 3.1 2013-10-01
Reset: Resets protection circuits and power supplies that were inhibited, but are now alarm-free. To
initiate an alarm reset from the front panel display, (see Resetting alarms on page 2-90).
Log Out: Click to log out of the AUI session and return to the login menu. To log in again, use your
remote PC’s keyboard to enter your Username and Password, then click the
Submit button. If you do
not have a user account, (see Setting User Accounts - see page 2-106).
The displays between the top and bottom menus, contains user selected pages. These pages provide
access to a variety of AUI functions such as transmitter status and hardware settings. The following
paragraphs describes how to use these pages.
Logging into the AUI
The transmitter’s AUI provides a means to restrict access to transmitter control functions to
authorized users only. There are user accounts that can be pre-defined to set access restriction from
read-only (no control) and full-administrative control.
Access the AUI using a web browser as follows:
1. Configure your network settings (Network Setup on page 2-111).
2. On your router or firewall software, open ports 3501 and 80 and close (restrict access to) port 22.
If you are using RDS data, open port 7005. If you are using SNMP, open port 161.
3. Gain remote access to the transmitter by entering the IP address in a web browser’s address field.
Your login remains active until the browser is closed.
4. When properly configured, the login menu (see Figure 2.7 on page 2-19) appears on the web
browser. Your IP address and any login messages appear in a box at the top, beside the logo, and
the current software version number appears along the bottom of the login window.
If the login menu does not appear, then your login may not be properly configured and you
should consult the documentation for the User Accounts page (System Settings - AUI on
page 2-92).
5. Log in to the AUI by entering the appropriate parameters in the login window.
• In the
Language field, click the down-arrow to review a drop-down menu displaying the
available language options, and select one.
To Next Page
Loading...
