EasyManuals Logo

Navistar WorkStar Series User Manual

Navistar WorkStar Series
258 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #107 background imageLoading...
Page #107 background image
Operation
8. To place the ignition switch in ACC (Accessory) position,
rotate key counterclockwise to the ACC position.
Accessory features can now be used without engine
operation.
9. To terminate ACC (Accessory) operation, rotate the key
clockwise to the OFF position.
After the Engine Starts
Do not increase engine speed until the oil pressure gauge
indicates normal pressure.
Make sure the engine oil pressure is indicated on the gauge
within 20 seconds after starting.
Operate the engine for three to ve minutes before operating
at full power.
Try to limit engine idle to 10 minutes. Excessive idling
reduces fuel economy, and may decrease oil life.
When starting a cold engine, increase the engine speed
(RPM) slowly to make sure adequate lubrication is available
to the bearings.
Engine ShutDown
Idle the engine for three to ve minutes before shutting down.
This few minutes of idling allows the lubricating oil and water
to carry heat away from components heat-soaked by hot
combustion/exhaust gasses.
The larger the engine, the greater the need for this idling period
and of course, the length of the idling period should somewhat
follow the size of the engine in order to avoid seals or like
features of an engine being damaged by rising heat.
1. Place the transmission in the (N) Neutral position.
2. Apply the parking brake.
3. Turn OFF the headlights and all accessories.
4. Idle a hot engine for 2 to 5 minutes to allow the
turbocharger to cool.
5. Rotate the key counterclockwise to the OFF position,
and remove key from the ignition switch.
Shut-Down Warning Indicator Or Beeper
WARNING
In the event engine shutdown occurs, make
certain that vehicle is safely off the roadway,
the 4-way emergency ashers are on, and trafc
warning devices are properly placed. Failure to
remove vehicle from roadway could cause an
accident and result in property damage, personal
injury, or death.
Vehicles may be equipped with an automatic shutdown system
that stops the engine in the event of high coolant temperature,
low engine oil pressure, or low coolant level. A warning indicator
on the instrument panel along with a beeper or bell will indicate
high coolant temperature or low oil pressure. If the temperature
and/or pressure continue to change beyond the warning point to
a predetermined level, the engine will automatically shut down.
Vehicles are equipped with an override feature that will allow the
3879634R1 95

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Navistar WorkStar Series and is the answer not in the manual?

Navistar WorkStar Series Specifications

General IconGeneral
BrandNavistar
ModelWorkStar Series
CategoryTrucks
LanguageEnglish

Related product manuals