EasyManuals Logo

Navistar WorkStar Series User Manual

Navistar WorkStar Series
258 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
Foreword
NOTE: Washing Instructions - Wash the vehicle with warm water
and mild soap, then wipe wet surfaces with a chamois or soft
cloth. DO NOT use hot water or strong soaps or detergents. DO
NOT wash the vehicle in direct sun, or when the sheet metal is
hot to the touch. This will streak the nish. DO NOT wipe dirt off
dry surfaces, as this will scratch the nish.
NOTE: When vehicles are stored outside, particularly in coastal
areas (salt water and high humidity atmosphere) or other
areas of corrosive environment, paint and bright metal may
require frequent washing and waxing to prevent deterioration.
Determining washing frequency is the customers responsibility.
NOTE: For vehicles exposed to ultraviolet rays of the sun, apply
a coating of Bon-Ami® soap, or similar product, to the inside
surfaces of the windshield and windows, to shade the interior
and prevent fading of the interior trim.
2. Inspect painted surfaces; touch up all exposed primed or raw
metal areas to prevent rust.
3. a thick coat of wax to prevent discoloration from the
elements; wax all chrome and stainless steel metal parts.
4. Check the radiator coolant for proper level and adequate
freeze protection [-20°F (-29°C) is standard for medium duty
models and bus chassis, -40°F (-40°C) is standard for heavy
duty models].
5. Cover open ends of vertical exhaust stack(s).
6. Drain air brake reservoirs and close the drain cocks.
7. Lubricate all exposed transmission, auxiliary transmission
and PTO shift rails.
8. Check state of charge eye in batteries and re-charge if
open circuit voltage is below 12.6 volts. Disconnect battery
ground cables to prevent accidental starting, or parasitic
electrical loads from discharging the battery.
Storage Duration - Over One Month
Units in storage longer than one month should be driven until the
engine reaches operating temperature:
1. Insure all tires are inated properly, remove vertical exhaust
stack covers and reconnect batteries.
2. Check all vehicle uid levels and ll as required.
3. Start and run the vehicle at fast idle, until it reaches operating
temperature. To remove surface charge from the battery,
built up from previous start-ups and short idle periods,
operate the heater and/or air conditioner, headlights and
other accessories for several minutes.
4. Turn off heater and/or air conditioner and any other
accessories; shut off the headlights. Park the vehicle and
shut off the engine.
5. Perform the procedure for Storage Duration - One Month
or Less, if returning the vehicle to storage.
NOTE: After every 30 additional days of storage, perform Items
1 through 5.
3879634R1 3

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Navistar WorkStar Series and is the answer not in the manual?

Navistar WorkStar Series Specifications

General IconGeneral
BrandNavistar
ModelWorkStar Series
CategoryTrucks
LanguageEnglish

Related product manuals