Controls/Features
Compass Directional Calibration Procedure
To begin the Compass Directional Calibration Procedure, stop
the vehicle in an area large enough to permit driving in complete
circles and perform the following steps:
Step Procedure Displayed Message
1
Select Quadrant 2 (lower right) on the instrument panel gauge cluster display by turning
the display control knob either clockwise or counterclockwise.
2
Select the Calibrate C
ompass message by pressing and releasing the display control
knob until this messa
ge appears.
3
Press and hold the display control knob until the End Calibration command is displayed.
NOTE: IF the End Calibration command will not show up, turn OFF the vehicle, restart it,
andreturntoStep1.
NOTE: The following steps (4 through 6) must be completed within 3 minutes to lock-in
the new calibration. Do not press the display control knob or turn the key OFF until
these steps are completed or the calibration process will be cancelled.
4
Immediately following the End Calibration command being displayed, drive the vehicle in
3 complete circles (during this time the compass display will go blank or have dashed
lines present).
3879634R1 55
To Next Page
Loading...
Need help?
General
