Controls/Features
Step Procedure Displayed Message
1
Select Quadrant 2 (lower right) on the display by turning the display control knob either
clockwise or counterclockwise.
2
Select the Compass Declination message by pressing and releasing the display control
knob until this message appears.
3
Press and hold the display control knob until any Declination Zone number (0 – 10) is
displayed.
4
Turn the display control knob clockwise or counterclockwise until the desired Declination
Zone number is displayed. Refer to Declination Zone Map to determine the proper
number for the current geographic location.
NOTE: If no Declination Zone number is selected within 15 seconds, the display will return
to the Compass Declination message.
NOTE: If the compass is being calibrated/recalibrated the Declination Zone must be set
to the Zone number for the location where the compass calibration/recalibration is being
performed regardless of the location where the vehicle will eventually operate.
5
Press and HOLD the display control knob until the Compass Declination message
appears (this indicates that the new Declination Zone number has been programmed
into the compass).
54 3879634R1
To Next Page
Loading...
Need help?
General
