Controls/Features
WARNING
Do not use the washers in freezing weather
without first warming the windshield with the
defrosters; otherwise, the washer solution may
freeze on the windshield and obscure your vision
and cause an accident which could result in
property damage, personal injury, or death.
Do not use radiator coolant or anti-freeze in the
windshield washer reservoir. Radiator coolant
in the washer reservoir can severely reduce
visibility when sprayed on the windshield.
Keep the fluid reservoir filled with Fleetrite® Windshield Washer
Solvent or equivalent.
4. Low/High Beam - When the turn signal stalk is pulled past
the “click” position, lights will switch to Hi-Beam position. When
pulled again they will revert to Lo-Beam.
Headlight Flash-To-Pass - When the turn signal lever is pulled
with the headlights OFF, the Hi-Beam lights will come on and stay
on as long as the lever is held in the pulled position. When the
Lo-Beam headlights are ON, the Hi-Beam lights can be made to
flash if the lever is not lifted past the ”click” or dimmer position.
5. Hazard Warning Switch - Red rocker switch located above
multipurpose turn signal lever. Push switch to forward position to
activate. The hazard warning flasher will operate with the ignition
switch in the ON or OFF position. Use the warning system any
time your vehicle becomes a traffic hazard, day or night. Push
switch rearward to deactivate.
Stop Override Hazard (Optional) - When hazard lights are
activated and the brake pedal is depressed, all hazard/turn
signal lights on the front, side lights of the truck, and the side
trailer lights will continue to flash. The rear lights of the truck or
tractor will burn steadily until the brake is released.
6. Tilting Adjustment Lever (Optional) - Allows the steering
wheel placement to be adjusted for driver comfort. Pull up to
adjust, push down to lock.
7. Trailer Brake Lever - This lever is used to apply and release
thebrakestothetrailer.
3879634R1 73
To Next Page
Loading...
Need help?
General
