7167 Owner’s Manual Chapter 6: Commands
November 2003
180
5 = Transmit Slip Paper Status
Bit Status Hex Decimal Function
0 Off 00 0 Fixed to Off
1 On 02 2 Fixed to On
2 Off
On
00
04
0
4
Slip paper selected
Receipt paper selected
3 Off
On
00
08
0
8
Not waiting for slip
Waiting for slip
4 On 10 16 Fixed to On
5 Off
On
00
20
0
32
Slip leading edge sensor: paper preset
Slip leading edge sensor: no paper
6 Off
On
00
40
0
64
Slip trailing edge sensor: paper preset
Slip trailing edge sensor: no paper
7 Off 00 0 Fixed to Off
Real Time Request to Printer
GS Sequence DLE Sequence
ASCII: GS ETX n or DLE ENQ n
Hexadecimal: 1D 03 n or 10 05 n
Decimal:
29 3 n or 16 5 n
Value of n:
1 = Recover and restart
2 = Recover and clear buffers
3 = Cancel slip waiting
The printer responds to a request from the host specified by n. This command includes
two sequences: GS and DLE. The operations performed depend on the value of n,
according to the following parameters.
n = 1:
Restarts printing from the beginning of the line where an error occurred, after recovering
from the error. Print settings that are normally preserved from line to line, such as
character height and width, are still preserved with this command. This sequence is
ignored except when the printer is busy due to an error condition.
If the receipt is selected, this command will attempt recovery from a knife error. Other
errors associated with the receipt, such as paper out or print head overheating, can be
recovered from only by clearing the specific condition, such as loading paper or letting the
print head cool down.
To Next Page
Loading...
