7167 Owner’s Manual Chapter 3: Solving Problems
November 2003
44
Green LED Blinking (Slow)
Problem What to Do Where to Go
Receipt paper is low*
There are about 4 ½ meters, ± 3 meters, (15
feet, ± 10 feet) of paper left. Change the paper
soon to avoid running out of paper part way
through a transaction.
See “Loading and
Changing the Receipt
Paper” in chapter 2.
Green LED Blinking (Fast)
Problem What to Do Where to Go
Receipt paper is out Change the paper now. Do not run a
transaction without paper as the data may be
lost.
See “Loading and
Changing the Receipt
Paper” in chapter 2.
Receipt cover or front cover is
open
Close the cover. The printer will not operate
with either of the covers open.
Knife failure Open the receipt cover and check the knife.
Clear any jammed paper you can see. Tear off
any excess paper against the tear-off blade.
Contact a service representative if this does
not resolve the problem.
See “Contacting a Service
Representative” later in
this chapter.
Paper jam in slip station Open the front cover and check the slip table
and under the carriage. Remove any paper
you see.
If you cannot see a paper jam or other
obstruction, contact a service representative.
See “Contacting a Service
Representative” later in
this chapter.
Paper jam in carriage Open Front Cover and clear paper from path.
Paper jam during flip If visible through Front Window, open access
door and clear paper jam, if not, open Front
Cover and clear jam.
To Next Page
Loading...
