NCR 7167 - Setting Switches; Printer Reset

7167 Owner’s Manual Chapter 3: Solving Problems
November 2003
7
Setting Switches
The DIP switches, located at the back of the printer, are used for three purposes:
• To set variables for several printer functions (see the sections for the various printer functions in
“Level 1 Diagnostics” in “Chapter 4: Diagnostics” for Setting Up The Printer)
• To perform diagnostic tests (see the sections for the various diagnostic tests in “Level 1
Diagnostics” in “Chapter 4: Diagnostics” for Setting Up The Printer)
Caution: The DIP switches are set to OFF.
Note: Switch 1 is shown in the Off position for reference.
Use a paper clip or other pointed object to set the switches.
1. Set the switches to the desired settings shown in the table.
2. Reset the printer.
Printer Reset
The printer is reset by disconnecting/reconnecting the DC power or by opening the slip door and
closing the slip door while holding the receipt paper feed button down.
DIP Switch
Switch 1 is shown in
the OFF
p
ositio
n
1
2
ON
Bottom
Cover
Back of Printe
r