7167 Owner’s Manual Chapter 4: Diagnostics
November 2003
60
** SET RECEIVE BUFFER SIZE ?
YES -> Long Click
NO -> Short Click
4K Buffer* -> Long Click
One Line -> Short Click
Note: Press the Paper Feed Button for at least one second to validate the selection.
Save Parameters
This function allows to save the selected communication settings or return to the
communication settings to select additional options.
Press the Paper Feed Button for the option you want.
Save new parameters ?
YES -> Long Click
NO, MODIFY -> Short Click
Diagnostic Modes
This function allows the user to put the printer into the following diagnostic modes:
OFF, Normal Mode: this is the normal operating mode of the printer.
Datascope Mode: the receipt printer prints incoming commands and data in hexadecimal format.
Slip test Mode: the slip printer prints two code pages.
Receipt Test Mode: the receipt printer prints two code pages.
MICR Test Mode: the receipt printer prints all characters recognized by the MICR.
Check Flip Test Mode: the check flip mechanism will flip an inserted check.
Print Head Gap Adjustment Mode: the slip printer prints several lines of rolling ascii even receipt
cover is open.
The diagnostic modes are enabled or disabled by using the Configuration Menu. See
“Configuration the Printer,” for instructions on how to enter the Configuration Menu.
Press the Paper Feed Button for the diagnostic mode you want.
** SET DIAGNOSTICS MODE ?
YES -> Long Click
NO -> Short Click
OFF, Normal Mode* -> 1 Click
Data Scope Mode -> 2 Clicks
Slip Test Mode -> 3 Clicks
Receipt Test Mode -> 4 Clicks
More Options -> 7 Clicks
Enter code, then hold Button DOWN
At least 1 second to validate
To Next Page
Loading...
